EasyManua.ls Logo

Bosch CMG7761B1 - 29.8.2 Grilling; 29.8.2.1 Recommended settings for grilling; 29.8.3 Microwave cooking; 29.8.3.1 Recommended settings for defrosting food using the microwave

Bosch CMG7761B1
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation instructions en
43
Grilling
Recommended settings for grilling
Food Accessories/cook-
ware
Shelf pos-
ition
Type of
heating
→Page11
Temperature in
°C/grill setting
Microwave
power setting
inW
Cooking
time in
mins
Toasting bread Pan support 3 3
1
- 3-6
1
Do not preheat the appliance.
Microwave cooking
¡ To test the microwave mode on its own, switch off
the drying function in the basic settings. →Page22
Recommended settings for defrosting food using the microwave
Food Accessory/cook-
ware
Shelf pos-
ition
Type of
heating
→Page11
Temperature in
°C
Microwave
power setting
in W
Cooking
time in
mins
Meat Uncovered cook-
ware
1 - 1. 180
2. 90
1. 5
2. 10-15
Recommended settings for cooking food using the microwave
Food Accessory/cook-
ware
Shelf pos-
ition
Type of
heating
→Page11
Temperature in
°C
Microwave
power setting
in W
Cooking
time in
mins
Custard Uncovered cook-
ware
1 - 1. 360
2. 180
1. 20
2. 20-25
Sponge Uncovered cook-
ware
1 - 600 7-9
Meat loaf Uncovered cook-
ware
1 - 600 22-27
Recommended settings for cooking in combination with the microwave
Food Accessory/cook-
ware
Shelf pos-
ition
Type of
heating
→Page11
Temperature in
°C
Microwave
power setting
in W
Cooking
time in
mins
Potato gratin Uncovered cook-
ware
1 150-170 360 25-30
Cakes Uncovered cook-
ware
1 190-210 180 12-18
Chicken, halved Uncovered cook-
ware
1 180-200 360 25-35
Installation instructions
30  Installation instructions
Observe this information when installing the appliance.
 30.1 General installation instructions
Follow these instructions before you start in-
stalling the appliance.
¡ The installation cabinet must not have a
back panel behind the appliance. There
should be a gap of at least 35mm
between the wall and the cabinet base as
well as the rear panel of the cabinet situ-
ated above.

Table of Contents

Related product manuals