8
Gas burners
Operation
There are indications to show which burner each control
knob operates. Fig. 1.
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to work
correctly. Fig. 2-3.
To turn on a burner
Connect the appliance by means of the main switch, its
indicator which will come on. Then turn the chosen
burner control to the left (anticlockwise) to the required
position. The flame will automatically and the hotplate
indicator light will come on.
If the main switch has been pushed but no burner
ignited, the appliance will switch itself off automatically
after 3 minutes.
If the burner goes out (e.g. a draught) when in use, the
appliance will switch the hotplate on again automatically.
If this ignition is unsuccessful (e.g. as a result of boiled-
over liquid on the burner), the flow of gas to this burner
is interrupted and the hotplate indicator flashes. Turn the
control knob to 0 and check whether the cause can be
rectified using the table on page 17.
To Next Page
Loading...
