Product Information
CR 10 H – 6720876740 (2017/08)
18
2 Product Information
Possible applications
• Room temperature-dependent controller (CO) for systems with one heating
circuit without mixer
• Remote control (Fb)
– in systems with higher-level user interface CW 400 with max. 4 heating
circuits or CW 800 with max. 8 heating circuits, and can be used solely as a
remote control in conjunction with heat sources with an external cylinder
primary pump
– can be used solely as a remote control in conjunction with heat pumps
(heating/cooling circuit controlled by HPC 400 or HPC 410). It captures the
room temperature and the relative humidity in the reference room
– The CR 10 H can be used as a remote control for the heating circuit and
ventilation, or heat pump and ventilation
• A humidity-sensitive controller. (OFF) for ventilation units. Humidity-sensitive
control, with up to 4 user interfaces. CR 10 H or if available, 4 ventilation zones
(1 user interface per ventilation zone)
Usage
• Heat source with 2-wire BUS system, EMS 2
• Combination with timers (e.g. MT10, ...) is possible
• Ventilation units with EMS 2
Scope of delivery
• User interface
• Technical documentation
To Next Page
Loading...
