What to do if water pressure in the heating system of my Bosch CR 10 H Controller is too low?
If the water pressure in your Bosch Controller's heating system is too low, top up the heating water. This can be done even without a specialist, referring to the technical documentation about the heat source.
How to troubleshoot no communication with the ventilation unit on my Bosch CR 10 H?
If your Bosch Controller isn't communicating with the ventilation unit, the first step is to check the cabling to ensure it's properly connected.
What to do if the remote control is not registered correctly in my Bosch Controller system?
If the remote control is not registered correctly in the Bosch Controller system, check and correct the configuration in the higher-level user interface. If the room temperature sensor for the remote control is faulty, replace the CR 10 H.
How to address a dirty filter issue in my Bosch CR 10 H Controller?
If the filter of your Bosch Controller is dirty, you should change the filter. After changing the filter, reset the filter running time in the FIL menu item by pressing the reset button.
How to fix CR 10 H if it is incorrectly configured on my Bosch Controller?
If the CR 10 H is incorrectly configured in your Bosch Controller, set A.1 = Fb (remote control) and set the ventilation.
What to do if the room temperature sensor for CR 10 H is faulty in my Bosch Controller?
If the room temperature sensor for the CR 10 H in your Bosch Controller is faulty, replace the CR 10 H.
How to resolve incorrect configuration of CR 10 H in heating circuit 1 in Bosch Controller?
If CR 10 H in heating circuit 1 is incorrectly configured in your Bosch Controller, and a higher-level user interface (e.g., CW 400) is installed, set A.1 = Fb (remote control). If no higher-level user interface and only one heating circuit is installed, set A.1 = CO (controller).
What should I do if the sensor for relative humidity in the remote control is faulty on my Bosch CR 10 H?
If the sensor for relative humidity in the remote control of your Bosch Controller is faulty, replace the faulty CR 10 H.
How to make ventilation level displayed on my Bosch Controller?
If the ventilation level is not displayed on your Bosch Controller, press the selector until the ventilation level appears.
Safety guidelines for installation and operation.
Precautions against frost damage to the system.
Lists the various uses and configurations of the CR 10 H.
Details how the CR 10 H is used with other systems.
Lists items included with the user interface.
Control method based on flow temperature deviation.
Using CR 10 H as a remote control for other systems.
How CR 10 H regulates ventilation based on humidity.
Energy efficiency data as per EU regulations.
How the CR 10 H acts as a room thermostat.
Explains the different display elements and their meanings.
How to adjust the target room temperature using the controller.
Procedure for turning off the heating function.
How to toggle between different display modes.
Adjusting the ventilation speed or mode.
Configuring specific ventilation programs or modes.
Steps and guidelines for physically installing the unit.
Instructions for wiring and connecting the device.
Procedures for initial setup and activation of the system.
Configuration for remote control mode with multiple circuits.
Setup for the ventilation unit when it is turned off.
Overview of configurable parameters in the service menu.
How to view energy usage data within the service menu.
Step-by-step guide for common operational tasks.
How to identify and record fault codes for diagnosis.
Lists common fault codes, their causes, and specialist remedies.
Detailed list of fault codes for technical personnel.
General| Brand | Bosch |
|---|---|
| Model | CR 10 H |
| Category | Controller |
| Language | English |
To Next Page