D1265 | User's Guide | Part II: System Commands
24 Bosch Security Systems, Inc. | 9/10 | F01U169131-02
13. The display prompts the user to exit the area
and starts counting down # seconds to arm the
system.
# is the number of seconds remaining in the
countdown.
14. When exit delay time expires and the system
turns on, the display shows:
15. To disarm, enter your personal passcode and
press ENTER.
Special Alerts (CMD + 7, CMD + 9)
Description
Commands 7 and 9 can be programmed to respond to
specific situations that might need immediate attention.
They might also be used to send a silent alarm to your
security company without sounding an alarm signal on
the premises. Check with your security company for
the options they offer.
Using CMD 7
1. Ensure your keypad shows idle text.
2. Press the CMD button. The display shows
*System Command*.
3. Press the 7 button.
If you prefer, you might use the function
list in place of Steps 2 and 3 to initiate
this function.
Press the Menu button to enter the
function list.
Press the Next button repeatedly.
When you reach the User Command 7
button, press it.
4. Your Command 7 special alert has been
programmed to:
notify your alarm company
ring a bell on your premises
display at your keypad
Description:
_________________________________________
_________________________________________
_________________________________________
To Next Page
Loading...
