Bosch D1265 - Unbypass a Point (CMD + 0 + 0); Description; Using Unbypass a Point

D1265 | User's Guide | Part II: System Commands
Bosch Security Systems | 9/10 | F01U169131-02 27
7. If the bypassed point is a Fire Point, the
message Fire Point Bypassed begins alternating
in the display with A1 Area Is Off.
8. If the bypassed point is a 24-hour point, the
message 24hr Point Bypassed begins
alternating in the display with A1 Area Is Off.
Unbypass a Point (CMD + 0 + 0)
Description
Unbypassing a point is a way to return a bypassed
point to the security system so that it can once again
respond to trouble and alarm conditions.
Using Unbypass a Point
1. Ensure the display shows disarmed idle text.
2. Press the CMD button. The display shows
*System Command*.
3. Press the 0 button twice.
If you prefer, you might use the function
list in place of Steps 2 and 3 to initiate
this function.
Press the Menu button to enter the
function list.
Press the Next button repeatedly.
When you reach the Unbypass a Point
button, press it.
4. You might be prompted for your passcode. It
appears on the display as asterisks (*).
5. The display changes to show Enter point
number or press next key.