Bosch D1265 - Part II: System Commands; Passcode Protected Commands; Turning the System On (Arming)

D1265 | Owner's Manual | Part II: System Commands
Bosch Security Systems, Inc. | 9/10 | F01U169130-02 15
Part II: System Commands
Some of these functions might not be
available in your system. Please consult
your security company to determine which
commands have been made available to
you.
If you attempt to enter a function that is not available
or if the function is available in the system but your
passcode is not authorized to perform the function,
then **No Authority**
shows on the keypad.
Press the CMD button and then the one or two digits
shown in Table 2 to perform the function. When you
use a command to perform a function, the displays in
the function list below do not appear at your keypad.
Some commands listed in Table 2 might
not be available. Contact your security
company for more information.
Table 2: Keypad Commands
COMMAND Function
Master Arm
+
Master Arm Instant
Perimeter Instant
Perimeter Delay
Silence Trouble Sounder and Clear
Trouble Display
+
View Memory
+
Walk Test
+
Reset Sensors
Watch Mode
Special Alert
Perimeter Partial
Special Alert
Bypass a Point
+
Unbypass a Point
Some commands listed below might not
be available. Contact your security
company for more information.