1 DVD-RW 2 Front Port Panel
To replace or install the front port panel:
1. Turn off and unplug the unit.
2. Remove the chassis cover.
3. Disconnect the power and data cables from the front port panel to other chassis
components including the motherboard and backplane.
4. Remove the old port panel by depressing the release tab, then pulling the unit out of the
chassis.
5. Insert the new front port panel unit in the slot until the tab locks into place.
6. Connect the data and power cables to the backplane and motherboard.
Installing the motherboard
Motherboard problems will be handled by trained support people only.
Installing the air shroud
Air shrouds concentrate airflow to maximize fan efficiency. The air shroud does not require
screws to set up.
3.7
3.8
DIVAR IP 7000 2U Chassis setup and maintenance | en 19
Bosch Sicherheitssysteme GmbH Installation Manual 2014.12 | V4 | DOC
To Next Page
Loading...
