DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations EN | 17
Bosch Security Systems | 6/05 | 4998154961B
6.2.8 Chime Mode
Chime Mode causes the keypad sounders to beep each time a Perimeter or Entry/Exit zone is triggered when the
control panel is off (disarmed). The [#][7] command is used to turn Chime Mode both off and on.
Table 16: Chime Mode
Action Equipment Command Sequence What Happens
Turn On
Chime Mode
Text keypad
LED keypad
RF3341 keypad
[PIN][#][7] • “Chime Mode On” is displayed for 5 seconds. *
• The LED flashes indicating a signal was sent to your security
system. **
• Keypad sounders beep for 2 seconds whenever a Perimeter
or Entry/Exit zone is triggered.
Turn Off
Chime Mode
Text keypad
LED keypad
RF3341 keypad
[PIN][#][7] • “Chime Mode Off” displays for 5 seconds. *
• The LED flashes indicating a signal was sent to your security
system. **
• Chime Mode is turned off.
* Text Keypad only ** LED Keypad only
6.2.9 Access Control
Your system might use a keypad key sequence to activate other electrical devices. Access control is not available
from an RF (wireless) keypad or from the keyfobs. Refer to Access Code on page 24.
This feature can be used in armed or disarmed modes.
The special PIN required to perform this function is known as an Access Control PIN. This PIN can control
devices that are activated for a short period of time (for example, electric locking mechanisms on a door). Access
PIN activations are recorded in the History Buffer.
Table 17: Access Control
Type of Disarming Command Sequence What Happens
Momentary Access Control Panel Activation [Access Control PIN][Off] The access device is activated for 10 seconds.
To Next Page
Loading...
Need help?
General
