FAS-420-TM Aspirating Smoke Detector Table of Contents | en 5
Bosch Sicherheitssysteme GmbH Operation Guide F.01U.088.878 | 4.1 | 2010.11
7 Maintenance 86
7.1 Visual check 86
7.2 Detector Module and Alarm Transfer 86
7.3 Pipe System 86
7.4 Replacing the Detector Module 87
7.5 Replacing the Air Filter in the Housing Base 88
7.6 Filter Change on the Filterbox 89
7.7 Blowing-out Process for the Pipe System 90
7.8 Checking the Airflow Sensor Calibration 90
7.9 Testing the Fire Source Identification 92
7.10 Airflow monitoring 92
7.11 Malfunction Transmission 92
7.12 Maintenance Intervals 92
8 Appendix 94
8.1 DIP Switch Settings for Detector Addresses 95
8.2 Planning without air filter 97
8.2.1 Without any other pipe accessories 97
8.2.2 With water separator 97
8.3 Planning with Air Filter 98
8.3.1 Without Any Other Pipe Accessories 98
8.3.2 With water separator 98
8.4 Test Log for Aspirating Smoke Detectors in the FAS-420-TM Series 99
Index 101
To Next Page
Loading...
