Conventional Automatic Detectors Installation | en 15
Bosch Sicherheitssysteme GmbH Operation Guide F.01U.002.707 | 8.0 | 2011.10
Figure 4.1 Activating the Removal Protection
4.6 Detector Removal
Unlocked detector heads are disassembled by turning them to the left and removing them
from the base.
Locked detector heads are disassembled by inserting a screwdriver into the unlocking
opening (Y) so that the bolt is pushed upward; at the same time, the detector head should be
turned to the left (refer to Figure 4.2).
Figure 4.2 Detector Removal (Locked Detector)
Legend
1 Bolt (X) prior to breaking out
2 Bolt (X) installed but inactive
3 Locking activated
X
X
123
X
X
Y
To Next Page
Loading...
