FlexiDome
XF & DN
| Installation Manual
Bosch Security Systems | 2005-10 | V1.0
EN | 7
Disassembly
The camera/housing unit consists of the following parts:
To disasemble the unit proceed as follows:
• Using the special screwdriver, loosen the three tamper resistant screws
in the trim ring (the screws remain in place).
• Remove the trim ring with dome by pulling it off of the base.
• Remove the inner liner by pulling it off of the base.
Caution
Installation should only be performed by qualified service
personnel in accordance with the National Electrical Code or
applicable local codes.
Caution
The camera module is a sensitive device and must be handled
carefully. Do not drop when disassembling the unit.
Camera module and
mounting base
Inner liner
Trim ring
Dome
To Next Page
Loading...
