Bosch FLEXIDOME IP micro 2000 User Manual

2
3 4
This equipment is only to be connected to
PoE networks without routing to outside plant
“This product is intended to be supplied by a Listed Power Unit marked
“Class 2”, “LPS”, or “Limited Power Source” and output rated 12Vdc, 0.
32A minimum; or 24Vdc, 0.16A minimum.”
)rewoP( krowteN
RJ45
Ethernet (PoE)
5 mm
(0.2 in)
12 VDC
24 VDC
22AWG
FLEXIDOME IP micro 2000 - Quick Installation Guide
1
microSDHC Card
(SD card does not include in the package)
elbmessasiD
x3
FRONT
FRONT
M3 Screw
Ø 6 mm
x2
x2
tnuoM
CABLE
0
90
180
270
Outer 6.0mm 2 Holes
For Plastic Anchor
Camera
Outline
Cut Line
Inner 2.5mm 2 Holes
For M3 Type Screws
FRONT
FRONT
Adjust
Pan
±175
°
Tilt
±70
°
Rotation
±180
°
NOTE: The angle of rotation should NOT be rotated over
180° in clockwise and counter clockwise.

Bosch FLEXIDOME IP micro 2000 Specifications

General

Maximum resolution	640 x 480 pixels
Supported video modes	240p, 480p
Video compression formats	H.264, M-JPEG
Pan range	0 - 350 °
White balance	Auto
Tilt angle range	0 - 55 °
Camera shutter type	Electronic
Camera shutter speed	0.00006 s
Minimum illumination	1 lx
Sensor type	CMOS
Progressive scan	Yes
Optical sensor size	1/4 \
Optical zoom	- x
Focus adjustment	2.8
Fixed focal length	2.5 mm
Security algorithms	3DES, DES, SSL/TLS
Built-in HDD	No
Compatible memory cards	MicroSDHC, MicroSDXC
Form factor	Dome
Product color	White
Type	IP security camera
PTZ control	-
Placement supported	Indoor
Connectivity technology	Wired
Interface	RJ-45
Ethernet LAN (RJ-45) ports	1
Audio formats supported	AAC
Cabling technology	10/100Base-T(X)
Supported network protocols	IPv4, IPv6, UDP, TCP, HTTP, HTTPS, RTP/RTCP, IGMP V2/V3, ICMP, ICMPv6, RTSP, FTP, Telnet, ARP, DHCP, SNTP, SNMP (V1, MIB‑II), 802.1x, DNS, DNSv6, DDNS, SMTP, iSCSI, UPnP (SSDP), DiffServ (QoS), LLDP, SOAP, Dropbox, CHAP, Digest Authentication
Compliance industry standards	802.3af
DC output voltage	+24V, +12V
Power source type	PoE
Power consumption (typical)	3.84 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %

Weight and Dimensions

Height	55 mm
Weight	250 g
Diameter	105 mm

Summary

Disassemble and Prepare

Disassembly Steps

Instructions for disassembling the camera unit into its main components.

MicroSDHC Card Slot

Note regarding the microSDHC card slot, not included in the package.

Mounting the Camera

Mounting Holes and Screws

Details on mounting hole sizes for anchors and screws, and screw types.

Camera Outline and Cut Line

Information on the camera outline and cut line for installation.

Network and Power Connection

Ethernet (PoE) Connection

Connecting the camera via RJ45 for Ethernet and Power over Ethernet.

DC Power Connection

Information on connecting a 12 VDC or 24 VDC power supply.

Power Supply Requirements

Notes on power supply specifications for safety and operation.

Adjusting Camera Position

Pan, Tilt, and Rotation Angles

Specifies the adjustable angles for pan, tilt, and rotation.

Rotation Limit Note

Warning about the rotation limit to avoid damage.

Fine-Tuning Camera Adjustment

Tree Mark for Adjustment

Guidance on using the tree mark for easier image direction adjustment.

Connecting to Bosch Video Client

Bosch Video Client Software

Instructions on accessing the camera via the Bosch Video Client.

Default IP Address

The default IP address for accessing the camera software.