Bosch GCM 10 PROFESSIONAL - Page 19

English–111 609 929 E91 • (04.10) PS
Floor Moldings
The following table contains instructions for the working of floor moldings.
Ceiling Molding (According to US Standard)
When the ceiling molding is to be work lying flat on the saw table, the standard miter angle of 31.6° (horizontal)
and 33.9° (vertical) must be set. (see Figure )
The following table contains instructions for the working of ceiling moldings.
Setting Placed
Against the
Fence
Lying Flat
on the Saw
Table
Vertical Bevel Angle 0° 45°
Floor Molding Left Side Right Side Left Side Right Side
Inner Corner Horizontal Miter
Angle
45° Left 45° Right 0° 0°
Positioning of the
Work Piece
Lower edge on
the saw table
Lower edge on
the saw table
Upper edge on
the fence
Lower edge on
the fence
The finished work
piece is located …
… to the left of
the cut
… to the right of
the cut
… to the left of
the cut
… to the left of
the cut
Outer Corner Horizontal Miter
Angle
45° Right 45° Left 0° 0°
Positioning of the
Work Piece
Lower edge on
the saw table
Lower edge on
the saw table
Lower edge on
the fence
Upper edge on
the fence
The finished work
piece is located …
… to the right of
the cut
… to the left of
the cut
… to the right of
the cut
… to the right of
the cut
R
Setting Placed
Against the
Fence
Lying Flat
on the Saw
Table
Vertical Bevel Angle 0° 33,9°
Ceiling Molding Left Side Right Side Left Side Right Side
Inner Corner Horizontal Miter
Angle
45° Right 45° Left 31.6° Right 31.6° Left
Positioning of the
Work Piece
Lower edge on
the fence
Lower edge on
the fence
Upper edge on
the fence
Lower edge on
the fence
The finished work
piece is located …
… to the right of
the cut
… to the left of
the cut
… to the left of
the cut
… to the left of
the cut
Outer Corner Horizontal Miter
Angle
45° Left 45° Right 31.6° Left 31.6° Right
Positioning of the
Work Piece
Lower edge on
the fence
Lower edge on
the fence
Lower edge on
the fence
Upper edge on
the fence
The finished work
piece is located …
… to the right of
the cut
… to the left of
the cut
… to the right of
the cut
… to the right of
the cut