To Next PageTo Next PageWhat to do if the LED light is flashing and the motor does not start on my Bosch GCM18V-12SD?
If the LED light on your Bosch Saw is flashing and the motor won't start, it could be due to overheating. Try letting the tool cool down. Alternatively, the battery might be too hot, in which case you should exchange the battery for a cooler one.
Why won't the motor start on my Bosch Saw?
If the motor of your Bosch Saw doesn't start, there are several possible reasons: * The battery pack might not be charged – charge the battery if needed. * The battery pack might not be installed properly – make sure the battery is correctly locked and secured to the tool. * The battery pack temperature could be too hot or cold – allow the battery to sit until it reaches a normal operating temperature. * The Electronic Motor Protection might have turned the tool off – remove and replace the battery. * The switch might be burned out – let the tool sit for a few minutes until it reaches a normal operating temperature.
Guidelines for maintaining a safe and well-lit work area to prevent accidents.
Precautions for safe electrical connections and usage to prevent shock hazards.
Advice on staying alert, using PPE, and preventing unintentional starting of power tools.
Instructions for the proper and safe use, maintenance, and storage of power tools.
Guidelines for safe charging, use, and handling of battery packs.
Steps to calibrate the miter detent system for accurate angle settings.
Procedure to adjust the miter scale pointer for precise angle readings.
Instructions for adjusting the 0° bevel stop for accurate blade alignment.
Instructions for adjusting the 45° bevel stop for accurate blade alignment.
Crucial advice on body and hand placement for safe and effective cutting.
Identification and importance of the 'No Hands Zone' to prevent injury.
Technique for using the sliding fence to maintain safe distance from the blade.
Essential safety procedure to check blade path and clear obstructions before cutting.
Information on the function and operation of the lower blade guard.
Explanation of the automatic electric brake and its function.
How to engage the Chop/Crown Lock for upright and crown cuts.
Step-by-step instructions for executing a chop cut.
Step-by-step instructions for executing a slide cut.
Step-by-step instructions for executing a compound cut.
Solutions for common electrical problems encountered with the tool.
Solutions for general operational issues and mechanical problems.
General