7
Technical data
Machine components
1 Protective guard
2 On/Off switch
3 Lock button
4 Handle
5 Ventilation slots
6 Base plate
7 Tap
8 Cutting line mark, 0°
9 Motor spindle
10 Mounting flange
11 Diamond cutting disc (optional accessory*)
12 Flange
13 Screw
14 Allen wrench – 5 mm
15 Open-ended spanner
16 Hose adapter
17 Hose
18 Screw for cutting depth setting
19 Cutting depth scale
20 Screw for cutting angle setting
21 Cutting angle scale
* Not all of the accessories illustrated or described are in-
cluded standard delivery.
Noise vibration
Measured values determined according to IEC 60745.
The A-weighted noise levels of the machine are typical-
ly: sound pressure level: 86 dB (A); sound power level: 99
dB (A).
Wear ear protection!
The weighted acceleration is typically 5.0 m/s
2
.
Intended use
The machine is designed for horizontal cuts mainly for min-
eral material, e. g. marble, using the base plate and posi-
tioned on a fixed base, both for wet cutting.
Attention!
It is prohibited to use the machine for works overhead.
This machine is not indicated for cuts in wood, plastic and
metallic materials.
For your safety
Working safety with this machine is pos-
sible only when the operating and safe-
ty information are read completely and
the instructions contained therein are
strictly followed. In addition, the general safety
instructions on page 14 must be followed. Before
using the tool for the first time, ask for a practical
demonstration.
• If the electric cable is damaged or cut through
while working, do not touch the cable but imme-
diately pull the mains plug. Never use the ma-
chine with a damaged cable.
• Wear protective goggles, ear protection and
dust protection mask.
• Wear protective gloves and sturdy shoes.
• When necessary, also wear an apron.
• Never allow children to use the machine.
• When working with the machine, always hold it firmly
with both hands and provide for a secure stance.
Diamond cutter GDC 14-40
Part number 0 601 548..
Rated power [W] 1400
Amperage [A]
127 V 11,0
220 V 6,4
No-load speed [min
–1
] 12000
Diamond cutting discs Ø [mm] 125
Mounting hole [mm] 20
Cutting depth max 0° [mm]
Disco 110 mm 33,5
Disco 125 mm 41,0
Cutting depth max 45° [mm]
Disco 110 mm 21,3
Disco 125 mm 26,5
Footplate [mm] 98,3 x 174,6
Weight (without optional extras) approx. [kg] 2,6
Safety class
/ II
GDC 14-40 13.10.05, 14:4711
•
Always direct the cable to the rear away from the ma-
chine.
•
Apply the machine to the workpiece only when switched
on.
•
Always switch off the machine and wait until it comes; to
a standstill before placing it down.
To Next Page
Loading...
