Time-setting options en
15
4. Press the l start/stop button to start.
The cooking time counts down on the display.
The appliance begins to heat up.
Once the cooking time has elapsed, a signal sounds.
The appliance stops heating. A cooking time of
00m 00s is shown on the display.
Use the s field to reset the cooking time or use the l
start/stop button to continue the operation without a
cooking time.
When your dish is ready, switch the appliance off using
the ÿ on/off button.
Changing and cancelling
To change the cooking time, touch the s field. The
cooking time is highlighted white and can be changed
using the rotary selector. Use the s field to accept the
change.
If you want to cancel the cooking time, reset the
cooking time to zero. After the change has been
applied, you can continue the operation without a
cooking time using the l Start/Stop button.
Setting the end time
You can delay the time that the cooking time ends. You
can, for example, put your dish in the cooking
compartment in the morning and set the cooking time
so that it is ready at lunch time.
Notes
■ Ensure that food is not left in the cooking
compartment for too long as it may spoil.
■ Do not adjust the end time once the operation has
started. The cooking result would no longer be
satisfactory.
Adjusting settings
The end of the cooking time can be delayed by a
maximum of 23 hours and 59 minutes.
Example in the picture: The set cooking time is 45
minutes and the dish should be ready at 12.00 p.m.
1. Set the heating type and temperature or level.
2. Set the cooking time.
3. Before starting, touch the s field again once.
On the display, the end time is displayed in white
and in focus.
4. Set a later end time using the rotary selector.
After a few seconds, the value is accepted, or touch
the s field again. The end time is shown on the
display under the operating mode and temperature
or level.
5. Press the l start/stop button to start.
The time at which the appliance starts is shown on
the display.
The appliance is in standby. When the appliance starts,
the cooking time counts down on the display.
Once the cooking time has elapsed, a signal sounds.
The appliance stops heating. A cooking time of
00m 00s is shown on the display.
Use the s field to reset the cooking time or use the
l start/stop button to continue the operation without a
cooking time.
When your dish is ready, switch the appliance off using
the ÿ on/off button.
Changing and cancelling
To change the end time, interrupt the operation using
the l Start/Stop button and then touch the s field
twice. The end time is highlighted white and can be
changed using the rotary selector. Continue the
operation using the l Start/Stop button.
If you want to cancel the end time, reset the end time to
zero. You can start the set cooking time immediately
using thel Start/Stop button.
Note: The end time can only be changed if the cooking
time has not elapsed. Otherwise the cooking result
would no longer be satisfactory.
_
7H[W
7H[W
P
V
a
&
_
7H[W
7H[W
7\SHVRIKHDWLQJ
¿
(QG
&RRNLQJWLPH
_
7H[W
7H[W
6WDUW
To Next Page
Loading...
