en Basic settings
16
14 Basic settings
You can configure the appliance to meet your needs.
14.1 Overview of the basic settings
Here you can find an overview of the basic settings
and factory settings. The basic settings depend on the
features of your appliance.
Basic setting Selection
Language See selection on the appli-
ance.
Clock Clock in 24-hour format.
Audible signal Short duration (30 seconds)
Medium duration (1 minute)
1
Long duration (5 minutes)
Button tone Switched on
Switched off (tone remains
for )
1
Display brightness 5 settings
Clock display Off
Digital
1
Lighting Off during operation
On during operation
1
Childproof lock Button lock only
1
Door lock and button lock
Operation after switch-
on
Main menu
Types of heating
1
AutoPilot
Night-time dimming Switched off
1
Switched on
Brand logo Display
1
Do not display
Fan run-on time Recommended
1
Minimum
Pull-out system Not retrofitted (if shelf sup-
ports and a single set of
pull-out rails are fitted)
1
Retrofitted (if two or three
sets of pull-out rails are fit-
ted)
1
Factory setting (may vary according to model)
Basic setting Selection
Sabbath mode Switched on
Switched off
1
Factory setting Reset
Do not reset
1
1
Factory setting (may vary according to model)
14.2 Changing the basic settings
Requirement:The appliance is switched off.
1.
Press and hold for approx. threeseconds.
2.
Press to confirm the messages in the display.
a The first basic setting is shown in the display.
3.
Use the control ring to change the basic setting.
4.
Press .
a The next basic setting appears in the display.
5.
Use to scroll through the basic settings and, if re-
quired, usethe control ring to change any of these
settings.
6.
To save the changes, press and hold for approx.
threeseconds.
Note:Your changes to the basic settings will be re-
tained even after a power failure.
Discarding changes to the basic settings
▶
Press .
a All changes will be discarded and not saved.
14.3 Setting the time
Requirement:The appliance is switched off.
1.
Press and hold for approx. threeseconds.
2.
Press to confirm the messages in the display.
a The first basic setting is shown in the display.
3.
Press .
a The "Time" basic setting is shown in the display.
4.
Use the control ring to change the time.
5.
To save the change, press and hold for approx.
threeseconds.
15 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
15.1 Cleaning products
In order to avoid damaging the various oven surfaces
on the appliance, do not use unsuitable cleaning
products.
WARNING‒Risk of electric shock!
An ingress of moisture can cause an electric shock.
▶ Do not use steam- or high-pressure cleaners to
clean the appliance.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
▶ Do not use harsh or abrasive cleaning products.
▶ Do not use cleaning products with a high alcohol
content.
▶ Do not use hard scouring pads or cleaning
sponges.
▶ Do not use any special cleaners for cleaning the ap-
pliance while it is hot.