Bosch HBG6764 1W Series - Setting End Time and Timer

Time-setting options en
17
3. Turn the rotary selector to set the cooking time.
The end time is calculated automatically.
4. Press the l start/stop button to start.
The cooking time counts down.
The appliance begins to heat up.
Once the cooking time has elapsed, an audible signal
sounds. The appliance stops heating. The cooking time
00m 00s is shown on the display.
You can reset the cooking time by using the "Cooking
time" text field or you can press the l start/stop button
to continue the operation without a cooking time.
When your dish is ready, switch the appliance off using
the ÿ on/off button.
Changing and cancelling
To change the cooking time, touch the "Cooking time"
text field. The cooking time is highlighted, and can be
changed using the rotary selector. The change is
adopted immediately.
If you want to cancel the cooking time, reset the
cooking time to zero. After the change has been
adopted, operating continues without a cooking time.
Setting the end time
You can delay the time that the cooking time ends. You
can, for example, put your dish in the cooking
compartment in the morning and set the cooking time
so that it is ready at lunch time.
Notes
■ Ensure that food is not left in the cooking
compartment for too long as it may spoil.
■ Do not adjust the end time once the operation has
started. The cooking result would no longer be
satisfactory.
Applying settings
The end of the cooking time can be delayed by a
maximum of 23 hours and 59 minutes.
Example in the picture: It is 10:00, the set cooking time
is 45 minutes and the dish should be ready at 12:00.
1. Set the operating mode, and temperature or level.
2. Set the cooking time.
3. Before starting the operation, touch the "End" text
field.
On the display, the projected end time is highlighted
in white.
4. Set a later end time using the rotary selector.
5. Press the l start/stop button to start.
The time at which the appliance will start is shown
on the display.
The appliance is in standby mode. When the appliance
starts, the cooking time counts down on the display.
Once the cooking time has elapsed, an audible signal
sounds. The appliance stops heating. The cooking time
00m 00s is shown on the display.
You can reset the cooking time by using the "Cooking
time" text field or you can press the l start/stop button
to continue the operation without a cooking time.
When your dish is ready, switch the appliance off using
the ÿ on/off button.
Changing and cancelling
After starting the appliance, the end time can no longer
be changed.
If you want to cancel the cooking time and end time,
interrupt the operation by pressing the l Start/Stop
button. You can continue the operation without a
cooking time or end time.
Setting the timer
The timer runs alongside other settings. You can set it
at any time, even if the appliance is switched off. It has
its own audible signal so that you can tell whether it is
the timer or a cooking time which has elapsed.
T
 P  V

(QG
&RRNWLPH

&
7HPSHUDWXUH
+RWDLUHFR
7\SHRIKHDWLQJ
&RRNWLPH

P  V
a 
&
&RRNWLPH
PV
(QG

U

PV
&RRNWLPH
(QG

&
7HPSHUDWXUH
+RWDLUHFR
7\SHRIKHDWLQJ
(QG

6WDUW
&RRNWLPH
PV
(QG
