10
11. Insert stripped end of red wire into the left lug.
12.-
ing screw.
13. -
ate torque (see table).
Gauge
Torque Torque (Nm)
6 35 3.95
8 25 2.82
14.
is now complete.
red wire
white wire
green
ground
screw
black wire
green ground wire
Note:
Three Wire Flexible Conduit Connection
-
cal codes and ordinances permit grounding through
-
cal, unit may be connected to the power supply via a
three wire connection.
1.
2. Remove the terminal block cover to expose the
terminal block.
3. Remove the top nut, star washer, and round
washer from each post.
Note:
internal wire leads.
4. Place one terminal lug (packaged with this man-
ual) on each post. Replace the star washer and
round washer and secure with 20" pounds of
torque.
5.
each wire.
3/8 “
6. Insert stripped end of white wire into the center
-
ping screw.
lug
clamping screw
wire
7. Insert stripped end of red wire into the left lug.
8. Insert stripped end of black wire into the right lug.
9.
Gauge
Torque Torque (Nm)
6 35 3.95
8 25 2.82
10. -
wiring is now complete.
green ground screw
Note:
To Next Page
Loading...
