6
Electrical Requirements
space.
21” (533.4 mm)
30”
(762 mm)
7 1/2”
(190.5 mm)
3 1/2”
(88.9 mm)
4 1/2”
(114.3 mm)
4 1/2”
(114.3 mm)
Verify that wiring to house is adequate.
Contact your local utility company to verify that the
present electric service to your home is adequate. In
some instances, the size of the wiring to the house
and service switch must be increased to handle the
electrical load demanded by the range.
Verify that wiring inside house is adequate.
separate disconnect switch and fuses either in the
main entrance panel or in a separate switch and
require that electrical wiring be done by licensed
to the electric codes in place in your region.
General Information
circuit breaker sizes based upon the supply voltage
for each model.
We recommend that the range be installed with a
electrical rating of the power cord set must be
set shall be marked
range can also be hard wired using the aluminum
terminal lugs included in the literature pack. If using
(not supplied).
-
fer to your local electric code requirements in order
to determine the required amperage.
for the circuit. In compliance with the NEC, a sepa-
rate circuit is also recommended.
Note: In Canada, the range is shipped from the fac-
tory with the range cord already installed. Proceed
the strain relief and connect the range cord (or wire
conductors) as described in the following steps.
Tips:
· -
ning while installing the range.
·
or a piece of cloth under the range to protect
·
To Next Page
Loading...
