Bosch HES7052C - Procedure; Prepare Electrical Connection

7
Procedure
Prepare Electrical Connection
Electrical Specifications
Check data plate for kW rating. Reference kW rating
in table to determine amperage requirements.
kW Rating AMPS Required

Volts

Volts


Canadian

12.3 9.2 40 or 50* 40 or 50*
12.6 9.5 40 or 50* 50
13.5 10.2 50 50
* Varies by location. Refer to local electric code.
Install Ventilation
We strongly recommend the installation of a ven-


-
cording to instructions furnished with the hood.
Prepare Walls and Floor
-
structions (extra electrical or gas connections, etc.)
so that range will rest against wall properly.
Prepare Range
Place range in front of cabinets where it is to be
installed. Remove any packaging.
Install Strain Relief
, WARNING

beproperly installed.
Place strain relief in knockout below terminal block.

-


per instructions included with strain relief.
Feed range cord through strain
relief in knockout panel here.
Electrical connection
(found behind terminal block cover)
Tip:
can be removed from the range to install the strain
relief: Remove panel from range, install strain relief

back panel.





-
mended method, but where local codes permit,
three wire connections are also acceptable.

can also be hard wired with either a three or four
wire connection. In this case, the terminal lugs sup-
plied must
be used.

-

information.