EasyManua.ls Logo

Bosch Indego M+ 700 - Docking Station and Power Supply Safety

Bosch Indego M+ 700
448 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English | 23
storage in winter. The built-in battery
is very long-lasting; do not open the
battery compartment until you no-
tice a significant reduction in the run
time between two battery charging
procedures.
u The Indego will operate between 5°C
and 45°C. If the battery temperature
is outside this range, the Indego will
display a message and will not leave
the docking station. If operating, the
Indego will return to the docking sta-
tion or stay in place.
u Recharge only in the Bosch ap-
proved docking station.
Safety Warnings for Docking Station
and Power Supply
u Only use the original Bosch dock-
ing station and power cord to
charge the mower. Otherwise there
is danger of fire and explosion.
u Check the docking station, power
supply unit, cables and plugs peri-
odically. If damage or ageing is de-
tected, isolate from the docking
station or power supply and do not
use them. Never open the docking
station or power supply yourself.
Have repairs performed only by a
qualified Bosch technician and
only using original spare parts. A
damaged docking station, power
supply, cable or plug increases the
risk of an electric shock.
u Do not operate the docking station
and power supply on easily flam-
mable surfaces (e.g., paper, tex-
tiles, etc.) or surroundings. The
heating of the docking station and
power supply during the charging
process can pose a fire hazard.
u Supervise children at all times.
This will ensure that children do not
play with the docking station, power
supply or the machine.
u The voltage indicated on the power
supply must correspond to the
voltage of the power source.
u We recommend that the power sup-
ply is only connected into a socket
which is protected by a circuit-
breaker that would be actuated by a
30mA residual current. Check your
Residual Current Device (RCD) at
regular intervals.
u The supply cord must be inspected
for signs of damage at regular inter-
vals.
u In the event of flooding of the dock-
ing station turn off power supply at
mains and contact Bosch Service
Centre.
u Never touch the mains plug or any
other plugs with wet hands.
u Do not run over, crush or pull the
cables. Protect the cables from heat,
oil and sharp edges.
The power supply is double insulated
for safety and requires no earth con-
nection. The operating voltage is
230VAC, 50Hz (for non-EU countries
220V, 240V as applicable). Contact
your Bosch Service Centre for details.
Bosch Power Tools F 016 L81 041 | (15.04.2020)

Table of Contents

Related product manuals