Bosch Indego M+ 700 - Page 31

English | 31
Problem Possible Cause Corrective Measure
Possible clogging Always turn isolator switch off first, then check under-
neath the mower. Clear out as necessary (always wear
protective gloves).
Battery not fully charged Place mower in the docking station to allow to charge.
Docking station must be on.
Grass too long Mow lawn with conventional lawnmower to its lowest
height-of-cut setting before using the mower.
Battery too hot/cold The mower operates when the battery internal battery
temperature is between 5°C – 45°C. Allow mower to
cool down/warm up. If the error occurs frequently, the
docking station should be positioned in the shade.
Mower standing on
lawn with the display
switched off
Operational problems Press confirm button for screen to light up, or place
mower in docking station.
Mower does not
charge
Battery too hot/cold The mower operates when the battery internal temperat-
ure is between 5°C – 45°C. Allow mower to cool down/
warm up. If the error occurs frequently, the docking sta-
tion should be positioned in the shade.
Docking station not switched on Switch on power supply to docking station. If docking
station does not start, contact your Bosch Service
Centre.
Charging pins corroded Clean the charging pins.
Battery not fitted, incorrectly fitted or in-
correct battery for mower
Insert battery correctly (see figure L). Use the appropri-
ate Bosch battery.
Mower out of peri-
meter wire
Perimeter wire on a slope Leave 30 cm between the perimeter wire and the slope.
Obstacle near perimeter wire Remove obstacle.
Parts of the lawn area
left uncut
Mower requires more cuts to finish garden Allow mower to run for 3 full cuts to cover whole lawn
area.
Time slot not long enough for garden size Increase mowing time slot or:
– use “Bosch AUTO” calendar function (with Indego M
700)
– use Bosch “SmartMowing” functionality (with In-
degoM+700)
Distance between perimeter wires too
small
Increase distance between the perimeter wires to a min-
imum of 75 cm.
Rough mowing conditions Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Flatten garden/remove/bumps/mark out unsuitable
areas with the perimeter wire – Please follow the instruc-
tions in the Installation Guide.
Grass too long Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Slopes in garden too steep Ensure mower only operates on slopes of 15 degrees or
less and full garden is not on a slope.
Mower gets stuck in
garden
Objects/obstacles not marked out Use the perimeter wire to mark off obstacles where the
mower often gets stuck.
Newly laid turf Allow a few weeks for the soil to settle before using the
mower.
Change setting in menu item "lawn condition / bump
sensor" to low sensitivity / uneven.
Bosch Power Tools F 016 L81 041 | (15.04.2020)