Bosch ISC-PPR1-W16 User Manual

This small animal immunity feature
was not investigated by UL.
nicht für VdS-Anlagen
IP41/IK04 (EN60529, EN62262)
EN 50131-1 Grade 2
EN 50130-5 Environmental Class II *
EN 50131-2-2
* Non coperto da certifi cazione IMQ
SELV
Connect all wiring to a safety extra-low voltage (SELV) circuit only.
Sluit alle bedrading uitsluitend aan op een circuit met een extra lage
veiligheidsspanning.
Prenez soin de connecter tous les câbles à un circuit à très basse tension de sécurité
limité en puissance (TBTS).
VdS number G 107504. VdS Plombe notwendig.
C-UL-US Use only a Listed limited-power source.
Standby Power: For UL and C-UL Listed product installation, the Listed control unit or a
Listed burglary power supply must provide four hours of stand by power.
C-UL For C-UL applications, install the unit in accordance with Part 1 of the Canadian Electrical
Code.
IMQ Certifi cato IMQ sistemi di sicurezza 2° livello di prestazione secondo CEI79-2:1998 +
Ab:2000
NF A2P (ISC-PPR1-W16 seulement)
Certifi cat NFA2P 2620392660
2 boucliers NF324 H58 RTC50131-2-2
www.afnor.org
www.cnpp.com
INCERT
B-509-0051/b
FCC/IC
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry and
Science Canada. Operation is subject to the following two conditions: (1) this device may
not cause harmful interferences, and (2) this device must accept any interference received,
including
interference that may cause undesirable operation.
www.boschsecurity.com
© 2011 Bosch Security Systems, Inc.
F01U261807-01
1
ISC-PPR1-W16
Commercial PIR
Installation Instructions

Bosch ISC-PPR1-W16 Specifications

General

Brand	Bosch
Model	ISC-PPR1-W16
Category	Accessories
Language	English

Summary

ISC-PPR1-W16 Product Overview and Certifications

Certifications and Standards

Details on safety, environmental, and compliance certifications for the device.

Small Animal Immunity Note

Information regarding the investigation status of small animal immunity features.

Installation and Wiring Guide

Installation Steps

Step-by-step visual guide for physical mounting and setup of the detector.

Terminal Connections and DIP Switch Settings

Explanation of terminal functions and DIP switch configurations for operational features.

Key Feature Explanations

Alarm Memory Function

How the Alarm Memory function operates and identifies alarms during armed periods.

Walk Test and Alarm Memory Polarity

Diagrams and guidance on setting polarity for Walk Test and Alarm Memory functions.

Coverage Patterns and Operational Settings

Detection Coverage Patterns

Visual representations of short and long range detection coverage areas.

Optional Features and Range Selection

Details on optional masking, look-down zones, and selecting detection range.

System Status and Tamper Protection

System Status and LED Indicators

Explanation of system states (set/unset) and the meaning of LED indicators.

Wall Tamper and Coverage Pattern Details

Information on wall tamper detection and further details on coverage patterns.