NL
Fix minor faults yourself
Before calling for the assistance of the After-Sales Service:
First check whether you can eliminate the malfunction by following the points below.
If you ask for a technician, and it turns out that he only needs to give advice (e.g. on
the operation or maintenance of the device) to rectify the fault, you will have to pay the
full costs, even during the warranty period. pay for that visit!
Malfunction Possible cause Solution
The temperature is very different
from the setting.
In some cases it is enough to
switch off the device for 5
minutes.
If the temperature is too hot: after a few hours,
check whether the temperature
the temperature setting is approached.
If the temperature is too cold: check
the temperature again the next day.
Warning signal
resounds.
Malfunction - it is too hot in the freezer
compartment!
To switch off the warning signal,
press the temperature setting
button Fig. "/1.
Temperature indication
flashes. Fig. "/3
Danger to the
frozen foods.
Device is open. Close device.
Guarantee ventilation and ventilation.The leg
vents are covered.
Too much food has been placed in the
freezer compartment at the same
time.
Do not exceed freezing capacity.
After the fault has been rectified, the
temperature display stops flashing.
The temperature in the freezer
compartment is too high.
The appliance door
was opened too often.
Do not open the appliance door unnecessarily.
The leg
vents are covered.
Remove covers.
There are larger
quantities of fresh food
frozen.
Do not exceed freezing capacity.
84
To Next Page
Loading...
