22 en | Installation IP Camera 200 Series
AR18-09-B003 | v1.1 | 2010.05 Installation and Operation Manual Bosch Security Systems
3.8 Camera set-up
To help set up the camera, connect a monitor to the miniature
2.5 mm jack socket using a S1460 monitor cable which can be
ordered separately. This monitor jack socket provides a
composite video signal (with sync) for installation purposes
only.
3.8.1 Camera positioning
The camera module position can be adjusted along three axes.
When adjusting the camera position ensure that the picture
display on the monitor is level.
S1460
CAUTION!
The image sensors are highly sensitive and require special care
for proper performance and extended lifetime. Do not expose
them to direct sunlight or bright spotlights in operating and
non-operating conditions. Avoid bright lights in the field of view
of the camera.
To Next Page
Loading...
