English | 19
Bosch Power Tools 1 609 929 W25 | (25.1.10)
Replacing the Insert Plate (see figure M)
The red insert plate 33 can become worn after
long use of the power tool.
Replace defective insert plates.
– Bring the power tool into the working posi-
tion.
– Unscrew screws 43 using a Phillips screw-
driver and remove the old insert plate.
– Insert the new insert plate and and screw all
screws 43 in again.
Sawing Profile Strips
Profile strips/mouldings can be sawn in two dif-
ferent ways:
Always make trial cuts with the mitre angle set-
ting first on scrap wood.
Checking and Adjusting the Basic
Adjustment
f Before any work on the machine itself, pull
the mains plug.
To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use.
A certain level of experience and appropriate
specialty tools are required for this.
A Bosch after-sales service station will handle
this maintenance task quickly and reliably.
Aligning the Angle Indicator (Horizontally)
(see figure N)
– Bring the power tool into the working posi-
tion.
– Turn the saw table 9 to the 0° detent 14. The
lever 11 must be felt to engage in the detent.
Checking:
The centre line of the angle indicator 13 must be
in line with the 0° mark of the scale 10.
Adjusting:
– Remove the insert plate 33.
– Loosen the screw 44 using a commercial
Phillips screwdriver and align the centre line
of the angle indicator alongside the 0° mark.
– Retighten the screw again.
Setting the Standard Bevel Angle 0°
(Vertical)
– Bring the machine into the transport posi-
tion.
– Turn the saw table 9 to the 0° detent 14. The
lever 11 must be felt to engage in the detent.
Checking: (see figure O1)
– Set an angle gauge to 90° and place it on the
saw table 9.
The leg of the angle gauge must be flush with
the saw blade 5 over the complete length.
Adjusting: (see figure O2)
– Loosen the clamping lever 29.
– Loosen the lock nut of stop screw 20 with a
ring spanner (13 mm).
– Screw the stop screw in or out until the leg
of the angle gauge is flush with the saw blade
over the complete length.
– Retighten the clamping lever 29 again.
– Afterwards, retighten the lock nut of the stop
screw 20 again.
In case the angle indicator 42 is not in a line with
the 0° mark of the scale 45 after the adjust-
ment, loosen the screw 46 using a commercial
Phillips screwdriver and align the angle indica-
tor along the 0° mark.
– Placed against the fence
– Lying flat on the saw
table
OBJ_BUCH-1142-001.book Page 19 Monday, January 25, 2010 8:52 AM
To Next Page
Loading...
