20 | English
1 609 929 W25 | (25.1.10) Bosch Power Tools
Setting the Standard Bevel Angle 45°
(Vertical)
– Bring the machine into the transport posi-
tion.
– Turn the saw table 9 to the 0° detent 14. The
lever 11 must be felt to engage in the detent.
– Loosen the clamping lever 29 and tilt the tool
arm leftward to the stop (45°) by the handle
2.
Checking: (see figure P1)
– Set an angle gauge to 45° and place it on the
saw table 9.
The leg of the angle gauge must be flush with
the saw blade 5 over the complete length.
Adjusting: (see figure P2)
– Loosen the lock nut of stop screw 19 with a
ring spanner (13 mm).
– Screw the stop screw in or out until the leg
of the angle gauge is flush with the saw blade
over the complete length.
– Retighten the clamping lever 29 again.
– Afterwards, retighten the lock nut of the stop
screw 19 again.
In case the angle indicator 42 is not in a line with
the 45° mark of the scale 45, firstly check the 0°
setting for the bevel angle and the angle indica-
tor again. Then repeat the adjustment of the 45°
bevel angle.
Aligning the Fence
– Bring the machine into the transport posi-
tion.
– Turn the saw table 9 until it engages at 0°.
Checking: (see figure Q1)
– Set an angle gauge to 90° and place it on the
saw table 9 between the fence 18 and the
saw blade 5.
The leg of the angle gauge must be flush with
the fence over the complete length.
Adjusting: (see figure Q2)
– Loosen all Allen screws 31 with an Allen key
6mm).
– Turn the fence 18 until the angle gauge is
flush over the complete length.
– Retighten the screws again.
Checking the Laser Beam Position
(see figure R)
– Draw a straight cutting line on the work-
piece.
– Push the locking lever 3 and guide the tool
arm slowly downward with the tool handle 2.
– Align the workpiece in such a manner that
the teeth of the saw blade are in alignment
with the cutting line.
– Hold the workpiece in this position and slow-
ly guide the tool arm upward again.
– Clamp the workpiece.
– Switch the laser beam on with switch 34.
The laser beam must be in alignment with the
cutting line on the workpiece over the complete
length, also when the tool arm is lowered.
Transport (see figure S)
Before transporting the power tool, the follow-
ing steps must be carried out:
– Bring the machine into the transport posi-
tion.
– Lock extension bar 7, ring spanner 17 and
screw clamp 6 with the corresponding fas-
tening screws 8, 16 and 30.
– Remove all accessories that cannot be
mounted firmly to the power tool.
If possible, place unused saw blades in an
enclosed container for transport.
– Carry the machine by the transport handle 1
or hold it by the recessed grips 47 on the
sides of the saw table.
f The power tool should always be carried by
two persons in order to avoid back injuries.
f When transporting the power tool, use only
the transport devices and never use the
protective devices.
OBJ_BUCH-1142-001.book Page 20 Monday, January 25, 2010 8:52 AM
To Next Page
Loading...
