English | 19
Bosch Power Tools 1 609 929 W96 | (10/5/10)
Sawing
Cutting Off
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Adjust the requested horizontal and/or verti-
cal mitre/bevel angle.
– Switch on the machine.
– Press lever 1 and slowly guide the tool arm
downward by handle 2.
– Saw through the workpiece applying uniform
feed.
– Switch off the machine and wait until the
saw blade has come to a complete stop.
– Guide the tool arm slowly upward.
Special Workpieces
When sawing curved or round workpieces,
these must be especially secured against slip-
ping. At the cutting line, no gap may exist be-
tween workpiece, fence and saw table.
Provide for special fixtures, if required.
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two dif-
ferent ways:
– Placed against the fence
– Lying flat on the saw table.
Always make trial cuts with the mitre angle set-
ting first on scrap wood.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings Placed
against
the fence
Lying flat
on the
saw table
Vertical bevel angle 0° 45°
Floor strip/moulding
Left side Right side Left side Right side
Inner corner Horizontal mitre
angle
45° left 45° right 0° 0°
Positioning of
workpiece
Bottom edge
on saw table
Bottom edge
on saw table
Upper edge
against the
fence
Bottom edge
against the
fence
The finished
workpiece is lo-
cated...
... to the left of
the cut
... to the right
of the cut
... to the left of
the cut
... to the left of
the cut
Outer
corner
Horizontal mitre
angle
45° right 45° left 0° 0°
Positioning of
workpiece
Bottom edge
on saw table
Bottom edge
on saw table
Bottom edge
against the
fence
Upper edge
against the
fence
The finished
workpiece is lo-
cated...
... to the right
of the cut
... to the left of
the cut
... to the right
of the cut
... to the right
of the cut
OBJ_BUCH-1247-001.book Page 19 Monday, May 10, 2010 10:21 AM
To Next Page
Loading...
