18 | English
1 609 929 W96 | (10/5/10) Bosch Power Tools
Starting Operation
f Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Switching On (see figure K)
–To start the machine, press the On/Off
switch 3 and keep it pressed.
Note: For safety reasons, the On/Off switch 3
cannot be locked; it must remain pressed during
the entire operation.
The tool arm can only be guided downward
when pressing lever 1.
–For sawing, you must additionally press lever
1 in addition to actuating the On/Off switch.
Switching Off
–To switch off the machine, release the
On/Off switch 3.
Working Advice
General Sawing Instructions
f For all cuts, it must first be ensured that the
saw blade at no time can come in contact
with the fence, screw clamps or other ma-
chine parts. Remove possibly mounted aux-
iliary stops or adjust them accordingly.
Protect the saw blade against impact and shock.
Do not subject the saw blade to lateral pressure.
Do not saw warped/bent workpieces. The work-
piece must always have a straight edge to face
against the fence.
Long workpieces must be underlaid or support-
ed at their free end.
Position of the Operator (see figure M)
f Do not stand in a line with the saw blade in
front of the machine. Always stand aside of
the saw blade. This protects your body
against possible kickback.
– Keep hands, fingers and arms away from the
rotating saw blade.
– Do not cross your arms when operating the
tool arm.
Permissible Workpiece Dimensions
Maximal workpiece sizes:
Minimal workpiece sizes
(= all workpieces that can be clamped left or
right from the saw blade with the supplied ma-
terial clamp 17):
170 x 45 mm (length x width)
Cutting capacity, max. (0°/0°): 89 mm
Replacing Insert Plates (see figure L)
The red insert plates 7 can become worn after
long use of the machine.
Replace defective insert plates.
– Bring the power tool into the working posi-
tion.
– Unscrew the screws 42 using the provided
Phillips screwdriver and remove the old in-
sert plates.
– Insert the new right-hand insert plate.
– Screw the insert plate as far as possible to
the right with the screws 42 so that the saw
blade does not come into contact with the in-
sert plate over the complete length of the
possible slide motion.
– Repeat the work steps in the same manner
for the left-hand insert plate.
Mitre/Bevel Angle Height x Width
[mm]
Horizontal Vertical at max.
height
at max.
width
0° 0°
89 x 89 60 x 130
45° 0°
89 x 59 57 x 89
0° 45°
58 x 85 38 x 120
45° 45°
38 x 76 38 x 76
OBJ_BUCH-1247-001.book Page 18 Monday, May 10, 2010 10:21 AM
To Next Page
Loading...
