EasyManua.ls Logo

Bosch PSB3A B20 Series - User Manual

Bosch PSB3A B20 Series
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Register your
new device on
MyBosch now and
get free benefits:
bosch-home.com/
welcome
Built-in gas hob
PSB3A.B20.
[en]
Information for Use

Questions and Answers

  • J
    James ThomasSep 9, 2025
    How to prevent damage from condensate returning to my Bosch Ventilation Hood?
    • A
      Allison Wilson DDSSep 9, 2025
      Install the exhaust duct in such a way that it falls away from the appliance slightly (1° slope).
  • D
    Dawn PriceAug 23, 2025
    Why won't the displays light up on my Bosch Hob?
    • B
      brownkyleAug 23, 2025
      If no displays light up on your Bosch Hob, it could be due to a disconnected power supply. Check other electrical appliances to see if there's a power failure. Also, ensure the appliance is connected according to the circuit diagram. If these steps don't resolve the issue, it may be an electronics fault, and you should contact technical after-sales service.
  • V
    victorcollinsAug 25, 2025
    What to do if the displays are flashing on my Bosch PSB3A B20?
    • S
      Sydney PonceAug 25, 2025
      If the displays on your Bosch Hob are flashing, it means that the control panel is wet or something is covering it. You should dry the control panel or remove the object.
  • G
    Gloria SmithAug 27, 2025
    How to prevent surface damage when cleaning my Bosch Ventilation Hood?
    • G
      gomezsusanAug 27, 2025
      To prevent surface damage when cleaning, clean stainless steel surfaces in the direction of the grain only. Do not use any stainless steel cleaners for operator controls.
  • A
    ashleyscottAug 27, 2025
    Why did my Bosch PSB3A B20 Hob cooking zone switch off?
    • M
      Mr. Matthew West MDAug 28, 2025
      If your Bosch Hob cooking zone switched off to protect the electronics, it is likely due to hot cookware being near the control panel. Remove the cookware, wait a few seconds, and touch any button. Once the fault display disappears, you can continue cooking.
  • R
    Richard DanielsAug 29, 2025
    How to prevent hot oil and fat from igniting in my Bosch Ventilation Hood?
    • D
      David HuertaAug 29, 2025
      To prevent hot oil and fat from igniting, never leave hot fat or oil unattended. Switch off the hotplate. Extinguish flames carefully using a lid, fire blanket or something similar.
  • K
    kelly88Sep 17, 2025
    Why is my Bosch Wine Cooler making noises?
    • E
      Eric BartonSep 18, 2025
      No action is required. The noises your Bosch Wine Cooler is making are normal.
  • W
    Wendy WardSep 22, 2025
    What to do if my Bosch Wine Cooler electronics have detected a fault?
    • D
      Daniel FlynnSep 22, 2025
      If the electronics in your Bosch Wine Cooler have detected a fault: disconnect the appliance from the mains, reconnect it after five minutes. If the message still appears on the display, call customer service.
  • A
    Angelica StaffordSep 7, 2025
    How to avoid corrosion damage to my Bosch Ventilation Hood?
    • B
      Barbara DavisSep 7, 2025
      To avoid damage due to corrosion, always switch on the appliance while cooking to avoid condensation.
  • C
    Chad AndersonSep 4, 2025
    How to prevent poisoning from flue gases with my Bosch Ventilation Hood?
    • J
      Justin BowmanSep 4, 2025
      Always ensure adequate fresh air in the room if the appliance is being operated in exhaust air mode at the same time as a room air-dependent heat-producing appliance.

Bosch PSB3A B20 Series Specifications

General IconGeneral
Number of Burners/Zones4
Control TypeTouch control
Boost FunctionYes
TimerYes
Child LockYes
Residual Heat IndicatorYes
Power Consumption7.4 kW
Voltage220-240 V
Frequency50-60 Hz
MaterialCeramic glass
Dimensions (W x D x H)592 x 522 x 51 mm

Related product manuals