Why my Bosch Oven cannot be switched off?
If you cannot switch off your Bosch Oven, it indicates a fault in the electronics. Immediately switch off the circuit breaker and contact aftersales service for assistance.
What causes surface damage to my Bosch Ventilation Hood?
Surface damage can occur if you use strong and abrasive cleaning agents. Never use these types of cleaners on your appliance.
How to prevent electric shock from moisture in my Bosch Ventilation Hood?
To prevent electric shock from penetrating moisture, clean the appliance using a damp cloth only. Before cleaning, pull out the mains plug or switch off the circuit breaker in the fuse box.
What to do if my Bosch Ventilation Hood is defective and may cause electric shock?
If your appliance is defective, never switch it on. Unplug it from the mains or switch off the circuit breaker in the fuse box.
How to prevent hot oil and fat from igniting in my Bosch Ventilation Hood?
To prevent hot oil and fat from igniting, never leave hot fat or oil unattended. Switch off the hotplate. Extinguish flames carefully using a lid, fire blanket or something similar.
Why did my Bosch PSB3A B20 Hob cooking zone switch off?
If your Bosch Hob cooking zone switched off to protect the electronics, it is likely due to hot cookware being near the control panel. Remove the cookware, wait a few seconds, and touch any button. Once the fault display disappears, you can continue cooking.
How to prevent surface damage when cleaning my Bosch Ventilation Hood?
To prevent surface damage when cleaning, clean stainless steel surfaces in the direction of the grain only. Do not use any stainless steel cleaners for operator controls.
What to do if the displays are flashing on my Bosch PSB3A B20?
If the displays on your Bosch Hob are flashing, it means that the control panel is wet or something is covering it. You should dry the control panel or remove the object.
Why won't the displays light up on my Bosch Hob?
If no displays light up on your Bosch Hob, it could be due to a disconnected power supply. Check other electrical appliances to see if there's a power failure. Also, ensure the appliance is connected according to the circuit diagram. If these steps don't resolve the issue, it may be an electronics fault, and you should contact technical after-sales service.
General| Number of Burners/Zones | 4 |
|---|---|
| Control Type | Touch control |
| Boost Function | Yes |
| Timer | Yes |
| Child Lock | Yes |
| Residual Heat Indicator | Yes |
| Power Consumption | 7.4 kW |
| Voltage | 220-240 V |
| Frequency | 50-60 Hz |
| Material | Ceramic glass |
| Dimensions (W x D x H) | 592 x 522 x 51 mm |
To Next Page
