BMW RCK3 VCI User Manual
Version 1.0.2 Page 9
© Bosch 2015
GETTING STARTED
Perform the following steps:
Step 1: Unpack your kit, check the contents.
Step 2: Install RCK3 software on the PC using the instructions to download the RCK3 software on
the paper insert provided in each kit.
Note: the RCK3 VCI should NOT be connected to the PC prior to installing the RCK3 software
Step 3: Connect one end of the USB cable to the RCK3 VCI and the other end to your computer
USB Port. Confirm the RCK3 VCI powers up.
Step 4: Start the RCK3 Software on the PC and wait for the message saying your RCK3 VCI
needs to be updated.
Step 5: Once the RCK3 VCI firmware update is complete, connect to the VCI from the RCK3 PC
software. The Host (PC) will flash a green LED when the PC and RCK3 VCI are connected.
To Next Page
Loading...
