4/104
Bosch Rexroth AG, A4... with HS5E pilot control valve/Series 3x, RE 92076-01-B/10.2017
6.1.1 Transporting with a lifting device 36
6.2 Storing the axial piston unit 38
7 Installation 40
7.1 Unpacking 40
7.2 Installation conditions 40
7.3 Installation position 42
7.3.1 Below-reservoir installation (standard) 42
7.3.2 Above-reservoir installation 43
7.4 Installing the axial piston unit 44
7.4.1 Preparation 44
7.4.2 Dimensions 44
7.4.3 General instructions 44
7.4.4 Installation with coupling 45
7.4.5 Installation on a gearbox 46
7.4.6 Installation with cardan shaft 46
7.4.7 Completing installation 47
7.4.8 Hydraulically connecting the axial piston unit 49
7.4.9 Electrically connecting the axial piston unit 54
7.5 Performing flushing cycle 55
7.6 Connecting the HS5E control system electrically 55
7.6.1 Wiring the electronic components 55
7.6.2 Connection to the swivel angle sensor 56
7.6.3 X2M1 and X2M2: Analog, configurable pressure sensor interface (coding A),
M12, 5-pin, socket 56
7.6.4 X7E1 and X7E2: Plug-in connector assignment for Ethernet port (coding D),
M12, 4-pin, socket 56
7.6.5 LED status indicators 57
7.6.6 Voltage supply of the HS5E pilot control valve 57
7.6.7 Selection, installation location, and installation direction of the pressure
transducer 58
8 Commissioning 60
8.1 Initial commissioning 61
8.1.1 Filling the axial piston unit 62
8.1.2 Testing the hydraulic fluid supply 63
8.1.3 Performing a functional test 63
8.1.4 Connection to the control (IndraWorks) 64
8.1.5 Making the basic setting on the control electronics 65
8.1.6 Switching on the drive motor of the pump 70
8.1.7 Setting controller parameters 71
8.1.8 Calibrating the HS5E control system 75
8.1.9 Saving parameters 76
8.2 Running-in phase 77
8.3 Recommissioning after standstill 77
9 Operation 78
10 Maintenance and repair 79
10.1 Cleaning and care 79
10.2 Inspection 80
To Next Page
Loading...
Need help?
General
