3−2 Electric Drives
and Controls
Bosch Rexroth AG BT 6.190 1070087068 / 01
Assembly and Connection
Dimensions of front
120
168
Required
assembly cutout
112
+1, −0
160
+1, −0
All dimensions in mm.
Required installation depth: approx. 40 mm
Maximmum thickness of mounting wall: 14 mm
Front panel thickness: 4 mm
Dimensions / assembly cutout for built−in unit
L Heed the information relevant to installation and assembly in the ”Notes
Regarding Safety” chapter.
L Mount the BT 6.190 in such a way that ergonomic operation is ensured.
The optimum reading angle of the LCD display is approx. 90_.
Remember that the front becomes dirty more quickly if mounting is hori-
zontal or at an angle.
max. 90 degrees
BT6.190
Optimum viewing angle:
90 degrees
L Ensure that the operator has an unobstructed view of moving machine
parts from the installation location at all times and that it is possible for
him to immediately activate the EMERGENCY STOP device of the sy-
stem in case of danger!
L Avoid installation locations that are subject to direct sunlight exposure
(this causes a reduction in the display readability and causes additional
heating of the display).
L To provide sufficient ventilation and room for cables, ensure that there is
at least 30 mm space above and below the device.
L Keep the device as far as possible from sources of interference (no less
than 25 cm).
To Next Page
Loading...
