30/48 Analog amplifier RA | Installation
BoschRexrothAG, RE95230-B/2021-12-01
Insert the concave side facing inwards,
to the contact carrier
Straight surface visible from the outside
Fig� 21: Insert seal
11� Push the sleeve over the cable entry opening and over the bead at the handle
shell. Afterwards, fix it with the wire tie.
– Ensure the correct seat of the sleeve over the handle shell and on the
insulation hose.
Bead at handle shell
Introduction of the sleeve must not be
folded up at insulation hose
Wire tie (lateral closing)
Fig� 22: Fixing the sleeve
– The lock of the wire tie must lie laterally at the recess of the sleeve.
To Next Page
Loading...
