40/48 Analog amplifier RA | Installation
BoschRexrothAG, RE95230-B/2021-12-01
• Switching solenoids at the switched output of the analog amplifier do not have
to be connected to aspark-suppression diode.
• Other inductive consumers that are in the system but not connected to the
analog amplifier must be connected to spark-suppression diodes. This also
applies to relays if they have the same supply as the amplifier.
7�5�5 Electrically connecting the analog amplifier
1� Make sure that the connector of the analog amplifier and the mating connector
of the wire harness are compatible. For pinassignment, see chapter 7.4.4
"Pin assignment" on page31.
2� Make sure that the mating connector of the wire harness is in de-energized
condition.
3� Connect the mating connector of the wire harness to the analog amplifier
connector until it engages noticeably and observe the correct plug-in position.
To Next Page
Loading...
Need help?
General