RE 30139-B/12.14 | VT-HNC100...X Bosch Rexroth AG 13/48
Information on this product
The preparation of user-specific data sets forms the basis for the function of the
VT-HNC100...3X. These data sets are created on the PC and submitted to the
VT-HNC100...3X via the serial interface or optionally the TCP/IP. The connection
between user program and data sets is referred to as project.
The VT-HNC100...3X includes different controller functions which are described in
the data sheet.
Technical data, operating conditions and the limitation of use of the
VT-HNC100...3X axis control are available in the data sheet.
4.3 Product identification
Fig. 2: Order code
VT-HNC100 = Serial unit
Version Compact for 1 axis = C
Version for 1 hydraulic axis = 1
Version for 2 hydraulic axes = 2
Version for 3 hydraulic axes = 3
Version for 4 hydraulic axes = 4
Component series 30 to 39 = 3X
(30 to 39: unchanged technical data and pinout)
Option
000 = without synchronization
G02 = Synchronization 2-axis version
G03 = Synchronization 3-axis version
G04 = Synchronization 4-axis version
00 = No fitting
E0 =
TCP/IP
1)
Position transducer
I = Incremental/SSI
(not in connection with Compact version)
S = SSI
(only in connection with Compact version)
Bus connection
2)
P = PROFIBUS DP
C = CANopen
N = PROFINET RT
(not in connection with Compact version)
E = EtherNet/IP
(not in connection with Compact version)
VT-HNC100
3X
1)
Only specify “E0” if the Ethernet service interface is desired
for “PROFIBUS DP”
2)
Versions without bus connection are not available.
To Next Page
Loading...
