40/48 Bosch Rexroth AG VT-HNC100...3X | RE 30139-B/12.14
Commissioning
The control types are listed on the download site for WIN-PED®.
The HNC software must be installed after download:
f Follow the installation instructions.
After having installed WIN-PED® and the control types, the WIN-PED®
program is ready for operation, and you can start the actual project planning,
programming and diagnosis of the control system.
The “First steps” which are available as download under
www.boschrexroth.com/hnc100 will support you when learning how to
use the software WIN-PED®.
Fig. 21: Download page for WIN-PED® and “First steps”
Fig. 22: First steps overview in WIN-PED® 6
The “First steps” will guide you through the whole installation and describe step
by step the creation of a new project, communication settings, the activation of
To Next Page
Loading...
