To Next PageTo Next PageWhy am I experiencing loss of pressure during ironing with my Bosch Iron?
If you experience a loss of pressure during ironing with your Bosch Iron, it might be because the steam release button is activated for too long. Use the steam release button at intervals to allow the textiles to dry and stay smooth better.
Why is my Bosch Sensixx B45L not heating up?
If your Bosch Iron isn't heating up, make sure the main power button is set to the “I” position (illuminated in red). Also, check that the temperature isn't set too low and adjust it to the desired position.
What to do if my Bosch Sensixx B45L isn't producing steam?
If your Bosch iron isn't producing steam, ensure the boiler is switched on and the water tank isn't empty. Set the main power button to the “I” position and fill the water tank. Also, check that the steam regulation isn't set to the minimum position; increase the steam flow.
Why does the ' ” icon lash on my Bosch Sensixx B45L?
The “ ” icon flashing on your Bosch iron indicates that the steam release button on the iron handle has not been pressed during the last 8 minutes, activating the auto shut-off system. Press the steam release button again to switch the steam station back on.
Why can't I hear the beep when touching the display of my Bosch Sensixx B45L Iron?
If you're hearing no beep when touching the display of your Bosch Iron, it might be because the beep has been deactivated. Reactivate it according to the instructions in this manual.
Why is my Bosch Sensixx B45L Iron display not reacting to touch?
If the display of your Bosch iron does not react when touched, clean it with a damp cotton fabric (not too wet). You might also need to warm your fingers a little bit and try again.
Why does my Bosch Sensixx B45L leave water spots on my clothes?
If water spots appear on the garment during ironing with your Bosch Iron, it's likely due to water condensing on the ironing board. Wipe the textile cover of the ironing board and iron any water drops to dry them.
What to do if my Bosch Sensixx B45L Iron doesn't stop steaming on the pad?
If the iron does not stop steaming after placing it on the pad, the “PulseSteam” function may have been activated by double-clicking. Just press the trigger once again, and the iron will stop steaming at once.
What to do if dirt comes out through the soleplate of my Bosch Iron?
If dirt comes out through the soleplate of your Bosch iron, it could be due to a build-up of scale or minerals in the steam tank, or the use of chemical products or additives. Use tap water mixed 50% with distilled or demineralised water. Clean the soleplate with a damp cloth, and never add products to the water.
Why does my Bosch Iron leak water through the soleplate?
Water flowing through the holes of the soleplate of your Bosch iron can occur because the steam function is being used before the iron has reached the correct temperature, or water is condensing inside the pipes from infrequent use. To resolve this, reduce the steam flow when ironing at low temperatures. You can also point the iron away from the ironing area and press the steam release button until steam is produced.
General| Power | 2400 W |
|---|---|
| Soleplate | Ceramic |
| Soleplate Material | Ceramic |
| Steam output | 40 g/min |
| Cord length | 2.5 m |
| Vertical Steam | Yes |
| Anti-Calc System | Yes |
| Drip-Stop System | Yes |
| Auto shut-off | Yes |
| Self-cleaning function | Yes |
| Anti-drip system | Yes |
| Type | Steam Iron |
