Solution 6000-IP
30 Bosch Security Systems 10/22 BLCC615U
User Guide
Devices and Optional Modules
Programming options in this section relate to the keypads
and other devices which may be connected to your alarm
system. Your installer will advise you on the exact makeup
and configuration of your system.
Devices > Commands >
Device Status
MENU 6-0-0
This option provides a listing of all of the devices and
modules connected to your system. Using this option
it is possible to view the voltage, temperature and other
information about each of the modules.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [0] + [0].
Kp1 Keypad 1 Name
Kp2 Keypad 2 Name
Ox1 Output Exp 1
Press OK or MENU
2. Use the [] and [] keys to select the device that you
want to view, then press [OK] to select.
The display will show each parameter for the device
one at a time on the third line of the screen.
Keypad 1 Name Kp1
Graphic + Prox V2.05
Voltage = 13.87
Press OK or MENU
4. Press [OK] or [MENU] to exit.
Devices > Commands >
Keypad Volume
MENU 6-0-7
This menu allows you to adjust the volume of the keypad’s
buzzer. Each keypad will need to have their volume
adjusted separately.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [0] + [7].
The keypad will display:
L
Keypad 001 Volume
Press
SAVE
OK
to
H
2. Use the [] and [] keys or use the [] and [] keys
to increase or decrease the volume of the keypad
buzzer until the desired volume has been reached.
3. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Devices > Commands >
Keypad Contrast
MENU 6-0-8
This menu allows you to adjust the contrast of the keypad’s
LCD display. Each keypad can have their display adjusted
separately.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [0] + [8].
The keypad will display the contrast screen.
L
Keypad 001 Contrast
Press
SAVE
OK
to
H
2. Use the [] and [] keys to adjust the bar until the
desired contrast is reached.
3. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Devices > Commands >
Keypad Backlight
MENU 6-0-9
This menu allows you to adjust the brightness of the
keypad’s LCD display backlight. Each keypad can have
their display adjusted separately.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [0] + [9].
The keypad will display the backlight screen.
L
Keypad 001 Backlight
Press
SAVE
OK
to
H
2. Use the [] and [] keys to adjust the bar until the
desired backlight is reached.
3. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Devices > Keypads & Readers >
Name
MENU 6-1-0
This menu allows you to program the name for each keypad
or reader connected to your system. Each name can be up
to 20 characters. You should program a name that help
to identify where the device is located in the building. eg.
Front Door Reader.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [6] + [1] + [0].
A list of available devices will display on the keypad.
2. Use the [] and [] keys to select the device name
To Next Page
Loading...
Need help?
General
