Cleaning the nozzle
Clean the nozzle after each use.
Place a suitable receptacle under the nozzle.
Briefly set function selector to ./!\,.
Avoid the risk of scalding!
When the function selector is set
to ./!\,, the nozzle may spurt slightly.
Escaping water is very hot. Do not
touch nozzle or direct at people!
Set function selector to _ position.
Wipe the outside of the nozzle after it has cooled
down.
Dismantle the nozzle to clean thoroughly.
Proceed as follows:
Unscrew the nozzle with a coin.
In particular, clean the tip of the nozzle with
a brush and pointed implement.
Clean all parts with hot water and detergent,
rinse and dry (dishwasher-safe).
27
To Next Page
Loading...
