10
Regulations
Tronic – 6 720 884 457 (2018/02)
3Regulations
The country’s regulations currently in force must be fulfilled for
the installation of the electric appliances.
4 Transport
▶ Do not drop the appliance.
▶ Remove the appliance from the packaging only at the place
of installation.
4.1 Transport, storage and recycling regulations
• The equipment should be stored in protected areas against
negative temperatures.
• Whenever applicable, the EU 2002/96/EC directive
imposed and the differentiated collection / gathering of
used electrical and electronic equipment.
5 Installation
5.1 Important notes
The water heater shall be installed as close as possible to the
outlets. When installing the water heater in a room with a
bathtub or shower, take into account the requirements defined
in IEC Standard 60364-7-701 (VDE 0100, Part 701).
It has to be fitted to the wall using appropriate wall screws with
a minimum diameter of 8 mm. A wall with a poor load-bearing
capacity must be properly reinforced where the heater will be
installed. The water heater may only be fixed upon the wall
vertically.
To facilitate future service interventions, you are advised to
install the heater in accordance with the installation
measurements.
5.2 Siting the appliance
Dispositions relative to the place of installation
• Comply with country-specific requirements
• Never install the appliance above a heat source.
• Never install the appliance in rooms where the ambient
temperature can fall below 0 °C.
• Install the appliance near the most frequently used draw-
off point to keep energy losses and waiting times to a
minimum.
• Install the appliance in a room that permits the replacement
of the magnesium anode, and necessary maintenance
procedures.
Protection areas 1 and2
▶ Do not install in protection areas 1 and 2.
▶ Install the appliance outside the protection areas at a
distance greater than 60 cm, of the bath.
Installation, power connection and
commissioning must only be carried out by a
service approved for such work by the local
entities.
CAUTION:
▶ Do not drop the appliance.
▶ Remove the appliance from the
packaging only at the place of
installation.
▶ Wherever applicable, comply with the
IEC 60364-7-701 norm on installing the
appliance and / or any electric
accessories.
▶ Chose a sufficiently robust wall to
support the appliance with the tank full
( see tab. 5).
CAUTION: Damage to the heating elements!
▶ Firstly connect all the water connections
and fill the appliance.
▶ Connect the appliance to the electric
point, assuring connection to earth.
CAUTION:
▶ Chose a sufficiently robust wall to
support the appliance with the tank full
( Tab. 4).
CAUTION:
▶ Make sure that the appliance is
connected to the DB board (electrical
board) with a connection to the earth
cable.
To Next Page
Loading...
