14
Installation
Tronic – 6 720 884 457 (2018/02)
5.6 Start-up
When filling the heater for the first time, the tap for the hot
water on the mixing tap must be opened. When the heater is
filled with water, the water starts to run through the outlet pipe
of the mixing tap.
Before start-up,
▶ Verify that the appliance has been correctly installed and
assembled.
▶ Open the water inlet valves.
▶ Open all the hot water taps in order to ensure all the air is
out of the connections.
▶ Control the tightness of all the connections and ensure that
the appliance fills to its full capacity.
▶ Connect the appliance to the electric current.
▶ Inform the customer of any user information of the
appliance and handling.
Before connecting it to the power supply, the
water heater must be filled with water.
To Next Page
Loading...
