de Cleaning and care
5. Insert the maintenance flap and 4th Clean the water drainage hose
and the siphon socket.snap into place.
2
1
1
6th Close the maintenance hatch. 5.
16.6 Clean the water drainage
hose on the siphon
If the water drainage hose on the
siphon is dirty or the detergent
solution is not pumped out, you must
clean it.
1. Switch off the device.
2. Disconnect the device's power plug
from the power supply.
3. Loosen the hose clamp and
carefully pull off the water
drainage hose.
16.7 Clean the filters in the
water inlet.
Empty the water inlet hose
To be able to clean the filters, first
empty the water inlet hose.
1. Turn off the tap.
2. Set a program, except
Rinse spin or Pump out.
Residual water can run out.
3. Start the program and let it run for
about 40 seconds.
4th Switch off the device.
5. Disconnect the device's power plug
from the power supply.
48
To Next Page
Loading...
