Troubleshooting de
disturbance Cause and troubleshooting
Wrinkling.
▶ For the next wash cycle, reduce the load
amount of manure.
The wrong program has been selected for the type of fabric.
▶ Select programs suitable for the type of textile
the end.
→
"Programs", page 26
Detergent or Too much detergent / fabric softener in the detergent
Fabric softener is dripping from the drawer.
the cuff and
collects on the door
or in the cuff.
▶ When dispensing liquid detergents, please note
tel and fabric softener mark the mark in the
detergent drawer and do not dose over it.
Spin result is
not satisfied-
lend. The laundry is
too wet / too damp.
The low spin speed is set.
▶ Set a higher one for the next wash cycle
Spin speed.
▶ Start the program Sling .
The drain pipe or water drainage hose is blocked.
▶ Clean the drain pipe and water drain
running hose.
The drain pipe or water drainage hose is kinked or
pinched.
▶ Make sure the drain pipe and the
The water drainage hose is not kinked or trapped.
The unbalance control system has stopped spinning
due to uneven distribution of the laundry.
▶ Redistribute the laundry in the drum.
Note: Place large and small items of laundry together
in the drum. Laundry items of different sizes are
better distributed during spinning.
▶ Start the program Sling .
The unbalance control system compensates for unbalance
by reducing the spin speed.
▶ Redistribute the laundry in the drum.
Note: Place large and small items of laundry together
in the drum. Laundry items of different sizes are
better distributed during spinning.
▶ Start the program Sling .
57
To Next Page
Loading...
