To Next PageTo Next PageWhat to do if my Bosch Water Wizard 600 Water Heater does not light?
If your Bosch Water Heater isn't lighting, the issue might stem from a lack of gas supply. Ensure it's properly connected to the supply. Another potential cause is a blocked pilot; if this is the case, consider replacing the pilot injector.
Why Bosch Water Wizard 600 Water Heater has low burner flame, water does not heat up?
If your Bosch Water Heater has a low burner flame and the water isn't heating up, it could be due to low inlet gas pressure. Check the supply regulator and pipe size. Another possibility is low burner pressure; in this case, check the appliance regulator.
Why Bosch Water Wizard 600 has low water temperature?
The low water temperature in your Bosch Water Heater may be due to several reasons. The water flow rate might be set too high, so try setting the flow rate appropriately. Alternatively, the gas pressure could be low, in which case you should check the pressure. Finally, the thermostat could be faulty or out of adjustment, requiring you to replace or adjust it.
Why Bosch Water Wizard 600 has low water flow?
The low water flow in your Bosch Water Heater could be due to several factors. It might be caused by low water pressure, so check and adjust as necessary. Alternatively, the water valve or heat exchanger could be blocked, requiring you to clean the filter or descale the unit, respectively. Lastly, check the shower rose or tap aerator for blockages and clean them if needed.
What to do if my Bosch Water Wizard 600 Water Heater pilot lights but no main burner?
If the pilot light is on but the main burner in your Bosch Water Heater isn't igniting, the issue might be a split or distorted diaphragm. If this is the case, you should replace it.
Why Bosch Water Heater shower goes hot & cold?
If your Bosch Water Heater is causing your shower to alternate between hot and cold, the problem might be a low flow water saver shower rose. Consider replacing it with a less restrictive rose and check operation at other tap.
Why Bosch Water Wizard 600 Water Heater has yellow flame?
A yellow flame in your Bosch Water Heater typically indicates that the burner venturi is blocked. Clean it using a venturi brush.
What to do if Bosch Water Wizard 600 Water Heater smells of gas?
If you notice a smell of gas coming from your Bosch Water Heater, it could be due to a luminous flame, in which case you should clean the burner. Another possibility is a loose gas connection; locate the leak using a soap solution.
What to do if Bosch Water Wizard 600 cuts off when operating?
If your Bosch Water Heater cuts off during operation, it could be due to a faulty or misadjusted thermostat, which would need replacement or adjustment. Alternatively, the wrong thermostat insert might be installed, so fit the correct part.
Why Bosch Water Heater operates only at high water flow?
If your Bosch Water Heater only operates at high water flow, the relief valve spring may be corroded, requiring you to replace the valve. Another possible cause is incorrect installation, where the cold supply is connected to the hot outlet; correct the installation.
Details of the Water Wizard 600 continuous flow gas water heater.
Emphasizes installation and servicing by authorized personnel only.
Outlines duties of the installer for commissioning and customer handover.
Warning that improper installation can void the warranty.
Bosch reserves the right to alter specifications for product improvement.
Instructions for wall mounting, heat shields, and minimum air gaps.
Specifies pipe sizes, gas cocks, and water valve requirements.
Recommendations for lagging pipes and installing pressure limiting valves.
Guidance on water filter installation and adjusting water temperature.
Details pilot orifice, burner injector diameters, and burner pressures by gas type.
Provides data on water flow rates and temperature rise for selector settings.
Instructions to prevent freezing damage and restrictions on installation in cold areas.
Prohibits installation in locations with prolonged sub-zero temperatures.
Information on obtaining spare parts or converting the unit for different gas types.
Step-by-step guide for safely lighting the appliance.
Instructions for operating the unit and adjusting temperature settings.
Key usage tips and procedures for shutting down the appliance.
Safety warnings related to pilot lights, flame, leaks, and gas smells.
Procedures for adjusting natural gas inlet and burner pressures.
Guidance for LP gas inlet pressure and burner pressure adjustments, including cylinder recommendations.
Recommendation for annual inspection and cleaning by an authorized person.
Troubleshooting guide for various issues like no ignition, low flame, leaks, and temperature problems.
Detailed troubleshooting for specific issues like yellow flame, water leaks, and intermittent operation.
Details warranty coverage, periods for domestic/commercial use, and heat exchanger.
Covers statutory rights, terms of sale, and conditions that void the warranty.
Information on service call charges and contact details for Bosch.
Details of the Water Wizard 600 continuous flow gas water heater.
Emphasizes installation and servicing by authorized personnel only.
Outlines duties of the installer for commissioning and customer handover.
Warning that improper installation can void the warranty.
Bosch reserves the right to alter specifications for product improvement.
Instructions for wall mounting, heat shields, and minimum air gaps.
Specifies pipe sizes, gas cocks, and water valve requirements.
Recommendations for lagging pipes and installing pressure limiting valves.
Guidance on water filter installation and adjusting water temperature.
Details pilot orifice, burner injector diameters, and burner pressures by gas type.
Provides data on water flow rates and temperature rise for selector settings.
Instructions to prevent freezing damage and restrictions on installation in cold areas.
Prohibits installation in locations with prolonged sub-zero temperatures.
Information on obtaining spare parts or converting the unit for different gas types.
Step-by-step guide for safely lighting the appliance.
Instructions for operating the unit and adjusting temperature settings.
Key usage tips and procedures for shutting down the appliance.
Safety warnings related to pilot lights, flame, leaks, and gas smells.
Procedures for adjusting natural gas inlet and burner pressures.
Guidance for LP gas inlet pressure and burner pressure adjustments, including cylinder recommendations.
Recommendation for annual inspection and cleaning by an authorized person.
Troubleshooting guide for various issues like no ignition, low flame, leaks, and temperature problems.
Detailed troubleshooting for specific issues like yellow flame, water leaks, and intermittent operation.
Details warranty coverage, periods for domestic/commercial use, and heat exchanger.
Covers statutory rights, terms of sale, and conditions that void the warranty.
Information on service call charges and contact details for Bosch.
General| Brand | Bosch |
|---|---|
| Model | Water Wizard 600 |
| Voltage | 240V |
| Energy Factor | 0.99 |
| Category | Water Heater |
| Type | Tankless Water Heater |
| Wattage | 12 kW |
| Temperature Range | 86°F to 140°F |
| Flow Rate | 6.6 GPM |
