NL Set up and connect
WARNING
Risk of injury!
When used on a plinth, the device can
tip over.
▶
The device feet for commissioning
on a plinth must be absolutely
with the fixings
→
Page 31
from the manufacturer
settle.
installation site
on a wall
To demand
no snakes
between wall and
device clamping
man.
PAY ATTENTION!
Residual water can freeze. Freezing
residual water can damage the
appliance and frozen hoses can burst.
▶
Do not place the device in areas
prone to frost or outdoors.
PAY ATTENTION!
The appliance may contain residual
water. If you tilt the appliance more
than 40°, residual water may leak out.
▶
Carefully tilt the device.
installation site
Plinth
To demand
4.4 Removing transport locks
The device with
locking lips
→
Page 31
confirm.
The device is secured for transport
with transport locks at the rear of the
device.
Remark: Keep the screws of the
transport locks and the sleeves for
later transport
→
Page 55
.
Floor with wooden
beams
Place the device
guess at a
resistant
wooden plate (thick-
too minimal
30mm) which
screwed to the
floor.
1. Pull the hoses out of the holders.
kitchen The device al-
borrow under a
continuous work
place sheet,
that fixed with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
14
To Next Page
Loading...
