Troubleshooting NL
s1
fix disruptions
8 Troubleshooting
sk
fix disruptions
You can remedy minor faults on the device yourself. Before using
contact customer service for information on troubleshooting. This way you
avoid unnecessary costs.
WARNING
Risk of electric shock!Improper repairs
are dangerous.
▶
Only trained specialist personnel may carry out repairs on the device.
▶
Only original spare parts may be used to repair the device.
▶
If the power cord of this appliance is damaged, it must be replaced by the
manufacturer, its service agent or a similarly qualified person in order to avoid
a hazard.
Malfunction Cause and Troubleshooting
The display is off and
Start/Refill
flashes.
The energy saving mode is active.
▶
Press any button.
a The display lights up again.
"E:30 / -80" Drain pipe or water drain hose is clogged.
▶
Clean the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
pinched.
▶
Make sure that the drain pipe and the water
drain hose are not kinked or pinched.
Drain pump is clogged.
▶
→
"Cleaning the drain pump", page 39
Water drain hose is connected too high.
▶
Install the water drain hose at a maximum height of 1
meter.
Pump cover not assembled correctly.
▶
Assemble the pump cover correctly.
Detergent dosage is too high.
▶
Immediate measure: mix a tablespoon of fabric
softener with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
▶
When the intelligent dosing is activated, reduce the
basic dosing amount
→
Page 37
.
43
To Next Page
Loading...
